Attività
 
Notifiche
Cancella tutti
Armin
Armin
Gruppo: Registrato
Registrato: 2022/07/17
Eminent Member
2
Randomly distributed small holes/gaps in my PLA model?

Nel forum How do I print this? (Printing help)

2 years fa
Thanks and what do you mean to 2.)?

Nel forum How do I print this? (Printing help)

2 years fa
More Stringing with heigher extrusion width?

Nel forum How do I print this? (Printing help)

2 years fa
Thanks, tried a lot, see below. Haven't done anything with t...

Nel forum How do I print this? (Printing help)

2 years fa
Here are my settings: Printer settings:Retraction length: 2-...

Nel forum How do I print this? (Printing help)

2 years fa
I attached the .3mf. Hopefully someone find something wrong....

Nel forum How do I print this? (Printing help)

2 years fa
Yes, I attached one below.

Nel forum How do I print this? (Printing help)

2 years fa
The upper diameter is 5mm.

Nel forum How do I print this? (Printing help)

2 years fa
Yes but the problem was since the purchase of the eSun filam...

Nel forum How do I print this? (Printing help)

2 years fa
Yes, I have small boxes with silica, ~35% humidity.

Nel forum How do I print this? (Printing help)

2 years fa
Yes I have set Prusa Slicer to expert mode otherwise I think...

Nel forum How do I print this? (Printing help)

2 years fa
Stringing on mk3s+ with eSun TPU 95a at transitions?

Nel forum How do I print this? (Printing help)

2 years fa
Yes, I also think that you have to try different thread tole...

Nel forum How do I print this? (Printing help)

2 years fa
Thread tolerances on Prusa mk3s+?

Nel forum How do I print this? (Printing help)

2 years fa
Pagina 2 / 2
Condividi: