Armin – Activité – Prusa3D Forum

Notifications

Clear all

Armin

Groupe: Enregistré

A(ont) rejoint: 2022/07/17

Eminent Member

	Randomly distributed small holes/gaps in my PLA model? Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks and what do you mean to 2.)? Dans le forum How do I print this? (Printing help)	il y a 2 years
	More Stringing with heigher extrusion width? Dans le forum How do I print this? (Printing help)	il y a 2 years
	Thanks, tried a lot, see below. Haven't done anything with t... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Here are my settings: Printer settings:Retraction length: 2-... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I attached the .3mf. Hopefully someone find something wrong.... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes, I attached one below. Dans le forum How do I print this? (Printing help)	il y a 2 years
	The upper diameter is 5mm. Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes but the problem was since the purchase of the eSun filam... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes, I have small boxes with silica, ~35% humidity. Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes I have set Prusa Slicer to expert mode otherwise I think... Dans le forum How do I print this? (Printing help)	il y a 2 years
	Stringing on mk3s+ with eSun TPU 95a at transitions? Dans le forum How do I print this? (Printing help)	il y a 2 years
	Yes, I also think that you have to try different thread tole... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thread tolerances on Prusa mk3s+? Dans le forum How do I print this? (Printing help)	il y a 3 years

Page 2 / 2 Précédent

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

18 En-ligne

70.2 K Membres

Le dernier des messages: Slicer 2.9.0 seam preview Notre nouveau membre: shugobha Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé