Armin – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

Armin

Gruppe: Registriert

Beigetreten: 2022/07/17

Eminent Member

	Randomly distributed small holes/gaps in my PLA model? Im Forum How do I print this? (Printing help)	Vor 2 years
	Thanks and what do you mean to 2.)? Im Forum How do I print this? (Printing help)	Vor 2 years
	More Stringing with heigher extrusion width? Im Forum How do I print this? (Printing help)	Vor 2 years
	Thanks, tried a lot, see below. Haven't done anything with t... Im Forum How do I print this? (Printing help)	Vor 2 years
	Here are my settings: Printer settings:Retraction length: 2-... Im Forum How do I print this? (Printing help)	Vor 2 years
	I attached the .3mf. Hopefully someone find something wrong.... Im Forum How do I print this? (Printing help)	Vor 2 years
	Yes, I attached one below. Im Forum How do I print this? (Printing help)	Vor 2 years
	The upper diameter is 5mm. Im Forum How do I print this? (Printing help)	Vor 2 years
	Yes but the problem was since the purchase of the eSun filam... Im Forum How do I print this? (Printing help)	Vor 2 years
	Yes, I have small boxes with silica, ~35% humidity. Im Forum How do I print this? (Printing help)	Vor 2 years
	Yes I have set Prusa Slicer to expert mode otherwise I think... Im Forum How do I print this? (Printing help)	Vor 2 years
	Stringing on mk3s+ with eSun TPU 95a at transitions? Im Forum How do I print this? (Printing help)	Vor 2 years
	Yes, I also think that you have to try different thread tole... Im Forum How do I print this? (Printing help)	Vor 2 years
	Thread tolerances on Prusa mk3s+? Im Forum How do I print this? (Printing help)	Vor 2 years

Seite 2 / 2 Vorherige

Forums-Statistiken

565 Foren

63.9 K Themen

447.6 K Beiträge

19 Online

69.5 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen