Čeština
Fóra
Uživatelé
Armin
Aktivita
 
Notifications
Clear all
Armin
Armin
Skupina: Registrovaný
Přidal se: 2022/07/17
Eminent Member
2
Profile Aktivita
Randomly distributed small holes/gaps in my PLA model?

In forum How do I print this? (Printing help)

 před 2 years
Thanks and what do you mean to 2.)?

In forum How do I print this? (Printing help)

 před 2 years
More Stringing with heigher extrusion width?

In forum How do I print this? (Printing help)

 před 2 years
Thanks, tried a lot, see below. Haven't done anything with t...

In forum How do I print this? (Printing help)

 před 2 years
Here are my settings: Printer settings:Retraction length: 2-...

In forum How do I print this? (Printing help)

 před 2 years
I attached the .3mf. Hopefully someone find something wrong....

In forum How do I print this? (Printing help)

 před 2 years
Yes, I attached one below.

In forum How do I print this? (Printing help)

 před 2 years
The upper diameter is 5mm.

In forum How do I print this? (Printing help)

 před 2 years
Yes but the problem was since the purchase of the eSun filam...

In forum How do I print this? (Printing help)

 před 2 years
Yes, I have small boxes with silica, ~35% humidity.

In forum How do I print this? (Printing help)

 před 2 years
Yes I have set Prusa Slicer to expert mode otherwise I think...

In forum How do I print this? (Printing help)

 před 2 years
Stringing on mk3s+ with eSun TPU 95a at transitions?

In forum How do I print this? (Printing help)

 před 2 years
Yes, I also think that you have to try different thread tole...

In forum How do I print this? (Printing help)

 před 2 years
Thread tolerances on Prusa mk3s+?

In forum How do I print this? (Printing help)

 před 2 years
Stránka 2 / 2
Share: