Notifications
Clear all
anthony.m26
anthony.m26
Grupa: Zarejestrowany
Dołączył: 2018/11/15
Active Member
1
Update: I changed to a new spool of PLA, discovered that my...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks for the suggestions. I'll be on the lookout for those...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks for the tip. I'll look into that. Are the results abo...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks for the responses. None of the software (firmware, sl...

In forum Assembly and first prints troubleshooting

6 years temu
Ah, something went wrong with the picture attachment. Thanks...

In forum Assembly and first prints troubleshooting

6 years temu
Print goes haywire at similar point each time

In forum Assembly and first prints troubleshooting

6 years temu
Thanks all for the suggestions! I wound up overcoming my fea...

In forum Assembly and first prints troubleshooting

6 years temu
I did manage to get it out of the way enough to make sure th...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks for the reply. I think it doesn't show up well in the...

In forum Assembly and first prints troubleshooting

6 years temu
Extruder fail

In forum Assembly and first prints troubleshooting

6 years temu
Thanks! Yes, as you'd suggested, the flat side of the motor'...

In forum Assembly and first prints troubleshooting

6 years temu
Sure enough! The flat side wasn't aligned with the grub scre...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks! Just seeing this reply. I posted another question ab...

In forum Assembly and first prints troubleshooting

6 years temu
Y axis length issue

In forum Assembly and first prints troubleshooting

6 years temu
Well, not quite. I'm back to the Y axis. I'm fearing that th...

In forum Assembly and first prints troubleshooting

6 years temu
Thanks. The connections seem fine, and after several attempt...

In forum Assembly and first prints troubleshooting

6 years temu
Bricked my printer?

In forum Assembly and first prints troubleshooting

6 years temu
Ehrmagerd. That's it. Thanks.

In forum Assembly and first prints troubleshooting

6 years temu
Unable to get past language selection

In forum Assembly and first prints troubleshooting

6 years temu
Share: