Prusa3D Forum

Notifications

Clear all

anthony.m26

Groupe: Enregistré

A(ont) rejoint: 2018/11/15

Active Member

	Update: I changed to a new spool of PLA, discovered that my... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks for the suggestions. I'll be on the lookout for those... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks for the tip. I'll look into that. Are the results abo... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks for the responses. None of the software (firmware, sl... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Ah, something went wrong with the picture attachment. Thanks... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Print goes haywire at similar point each time Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks all for the suggestions! I wound up overcoming my fea... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	I did manage to get it out of the way enough to make sure th... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks for the reply. I think it doesn't show up well in the... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Extruder fail Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks! Yes, as you'd suggested, the flat side of the motor'... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Sure enough! The flat side wasn't aligned with the grub scre... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks! Just seeing this reply. I posted another question ab... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Y axis length issue Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Well, not quite. I'm back to the Y axis. I'm fearing that th... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks. The connections seem fine, and after several attempt... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Bricked my printer? Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Ehrmagerd. That's it. Thanks. Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Unable to get past language selection Dans le forum Assembly and first prints troubleshooting	il y a 6 years

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

20 En-ligne

68.8 K Membres

Le dernier des messages: What’s the best nozzle? Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé