Prusa3D Forum

Avisos

Vaciar todo

anthony.m26

Grupo: Registrado

Registrado: 2018/11/15

Active Member

	Update: I changed to a new spool of PLA, discovered that my... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks for the suggestions. I'll be on the lookout for those... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks for the tip. I'll look into that. Are the results abo... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks for the responses. None of the software (firmware, sl... En el foro Assembly and first prints troubleshooting	hace 6 years
	Ah, something went wrong with the picture attachment. Thanks... En el foro Assembly and first prints troubleshooting	hace 6 years
	Print goes haywire at similar point each time En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks all for the suggestions! I wound up overcoming my fea... En el foro Assembly and first prints troubleshooting	hace 6 years
	I did manage to get it out of the way enough to make sure th... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks for the reply. I think it doesn't show up well in the... En el foro Assembly and first prints troubleshooting	hace 6 years
	Extruder fail En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks! Yes, as you'd suggested, the flat side of the motor'... En el foro Assembly and first prints troubleshooting	hace 6 years
	Sure enough! The flat side wasn't aligned with the grub scre... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks! Just seeing this reply. I posted another question ab... En el foro Assembly and first prints troubleshooting	hace 6 years
	Y axis length issue En el foro Assembly and first prints troubleshooting	hace 6 years
	Well, not quite. I'm back to the Y axis. I'm fearing that th... En el foro Assembly and first prints troubleshooting	hace 6 years
	Thanks. The connections seem fine, and after several attempt... En el foro Assembly and first prints troubleshooting	hace 6 years
	Bricked my printer? En el foro Assembly and first prints troubleshooting	hace 6 years
	Ehrmagerd. That's it. Thanks. En el foro Assembly and first prints troubleshooting	hace 6 years
	Unable to get past language selection En el foro Assembly and first prints troubleshooting	hace 6 years

Estadísticas del Foro

559 Foros

62.9 K Temas

443 K Respuestas

20 En línea

67.7 K Miembros

Último Mensaje: Gibt es ein Update von MK3.5 zu Mk4/S Nuestro miembro más reciente: pinklemonade Últimos Mensajes Publicaciones sin leer Etiquetas

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado