Prusa3D Forum

Notifications

Clear all

anthony.m26

Skupina: Registrovaný

Přidal se: 2018/11/15

Active Member

	Update: I changed to a new spool of PLA, discovered that my... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks for the suggestions. I'll be on the lookout for those... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks for the tip. I'll look into that. Are the results abo... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks for the responses. None of the software (firmware, sl... In forum Assembly and first prints troubleshooting	před 6 years
	Ah, something went wrong with the picture attachment. Thanks... In forum Assembly and first prints troubleshooting	před 6 years
	Print goes haywire at similar point each time In forum Assembly and first prints troubleshooting	před 6 years
	Thanks all for the suggestions! I wound up overcoming my fea... In forum Assembly and first prints troubleshooting	před 6 years
	I did manage to get it out of the way enough to make sure th... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks for the reply. I think it doesn't show up well in the... In forum Assembly and first prints troubleshooting	před 6 years
	Extruder fail In forum Assembly and first prints troubleshooting	před 6 years
	Thanks! Yes, as you'd suggested, the flat side of the motor'... In forum Assembly and first prints troubleshooting	před 6 years
	Sure enough! The flat side wasn't aligned with the grub scre... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks! Just seeing this reply. I posted another question ab... In forum Assembly and first prints troubleshooting	před 6 years
	Y axis length issue In forum Assembly and first prints troubleshooting	před 6 years
	Well, not quite. I'm back to the Y axis. I'm fearing that th... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks. The connections seem fine, and after several attempt... In forum Assembly and first prints troubleshooting	před 6 years
	Bricked my printer? In forum Assembly and first prints troubleshooting	před 6 years
	Ehrmagerd. That's it. Thanks. In forum Assembly and first prints troubleshooting	před 6 years
	Unable to get past language selection In forum Assembly and first prints troubleshooting	před 6 years

Fórum Statistiky

565 Fóra

63.9 K Témata

447.7 K Příspěvky

26 Online

69.5 K Uživatelé

Poslední Příspěvek: SMOOTH PEI SHEET und PETG Nový Uživatel: SilenceDIY Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed