VASE MODE : last layer flattening on a MODIX big 120Z
 
Benachrichtigungen
Alles löschen

VASE MODE : last layer flattening on a MODIX big 120Z  

  RSS
3dpoptrophées
(@3dpoptrophees)
Mitglied
VASE MODE : last layer flattening on a MODIX big 120Z

Hi there,

question about vase mode's last layer. I do use this mode for a while. It works perfectly with Prusaslicer and an MK3S+.

I also have a MODIX Big 120Z that I run with Prusaslicer too, in vase mode. Everything goes well, unless the last layer.

On my MK3S+, with Prusaslicer, last layer finishes perfectly, as the volumetric flow lowers progressively and height stays at the same value.

On my MODIX big 120Z, with Prusaslicer, last layer finishes abruptly, without any variation of volumetric flow or height change.

Do you know how to get this type of finishing on another printer than a Prusa one ?

To print on a MODIX big 120Z with Prusaslicer, MODIX provided me the beginning and finishing gcodes. The solution may be here...?

You'll see enclosed pics from MK3S+ and MODIX, and previews from Prusaslicer.

 

Thank you guys for your answers 😉

perfect finish

Prusa MK3S+, perfect finish !

perfect finish

Prusa MK3S+, perfect finish !

prompt finish

MODIX big 120Z, :X

prompt finish

MODIX big 120Z, :X

last layer on a MODIX big 120Z

last layer on a MODIX

last layer on a MK3S+

last layer on an MK3S+

 

Veröffentlicht : 23/08/2024 10:03 am
Teilen: