Slicer refuses to start on layer one
 
Notifications
Clear all

Slicer refuses to start on layer one  

  RSS
texanman
(@texanman)
New Member
Slicer refuses to start on layer one

Hi  folks. I have ran into a bug with pursaslicer that is pulling my hair out.

 

Up until a few days ago Pursaslicer was working fine. I am able to simply load in a model, pick face to go on the bed, then slice and save. However when this started happening when previewing the print before exporting it seems that the layer is starting on some randomly high position (based on the bottom timeline). I have search the net as best as I could to try and find what was going on. Even went as dratsitc to remove all the Prusa software and save files from my mac. However when setting up the slicer fresh it still does this stame thing. 

Posted : 04/09/2022 10:05 pm
Diem
 Diem
(@diem)
Illustrious Member

I suspect your model has some edge too thin to print and so the lower layers are missing but still logically support the model above the plate.

Please save your project as a .3mf file

Files > Save Project as

Zip the .3mf and post it here. It will contain both your part and your settings for us to diagnose.

Cheerio,

Posted : 04/09/2022 10:56 pm
R&D
 R&D
(@rd)
Estimable Member
RE: Slicer refuses to start on layer one

Perhaps you could provide a zipped up project file for users here to view? I recognize that this is difficult to do here but it could help.

Posted : 05/09/2022 3:41 am
fuchsr
(@fuchsr)
Famed Member
RE: Slicer refuses to start on layer one

Smart money is on @diem's diagnosis. 

Posted : 05/09/2022 4:05 pm
Share: