Set external walls to be 0.1mm and infilt to 0.2mm ?
 
Notifications
Clear all

Set external walls to be 0.1mm and infilt to 0.2mm ?  

  RSS
Vido
 Vido
(@vido)
Active Member
Set external walls to be 0.1mm and infilt to 0.2mm ?

I looked up on internet and I searched in Prüša Slicer but I could not find this option

so basically I want outer layer of object to be 0.1mm so to do 2 passes and infill layer to be 0.2mm ?

Best Answer by JoanTabb:

with a 0.4mm nozzle and layer height 0.1mm, you could set the value to 2, or 3 
and that is all you need to change

regards Joan

Napsal : 25/10/2023 12:18 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Set external walls to be 0.1mm and infilt to 0.2mm ?


Print Settings, Infill, Reducing Printing time... 

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 25/10/2023 1:21 pm
Vido
 Vido
(@vido)
Active Member
Topic starter answered:
RE: Set external walls to be 0.1mm and infilt to 0.2mm ?

 

 

Posted by: @joantabb


Print Settings, Infill, Reducing Printing time... 

regards Joan

So I need to set ti to "2" ? And that's it ?

Napsal : 25/10/2023 1:26 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE:

with a 0.4mm nozzle and layer height 0.1mm, you could set the value to 2, or 3 
and that is all you need to change

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 25/10/2023 1:43 pm
Share: