Notifications
Clear all
PS 2.3.0 takes about a minute to launch
Hi, I have been using PS 2.3.0 Windows 10 since it became available. Usually it launched very quickly in a few seconds but for the past two days, it takes about a minute to launch. I keep getting "Preparing setting tab" during launch. What is that? How can I speed it up like before?
Posted : 14/05/2021 4:42 am
RE: PS 2.3.0 takes about a minute to launch
https://forum.prusa3d.com/forum/prusaslicer/slicer-wont-start-hangs-on-preparing-settings-tabs/
Posted : 14/05/2021 10:24 pm
RE: PS 2.3.0 takes about a minute to launch
I have noticed the delay in launching. You get used to it.
--------------------
Chuck H
3D Printer Review Blog
Posted : 15/05/2021 2:54 pm
RE: PS 2.3.0 takes about a minute to launch
Turn off the CHECK FOR UPDATES feature.
Posted : 15/05/2021 9:48 pm