Notifications
Clear all
Need help: Thin Walls: Transition to thicker parts
Dear forum,
I'm trying to print the attached part, but I need a little strength in the thin wall.
But since the thin part of the wall is not printed in one go with the thicker parts there won't be a strong bond between them.
Wall thickness is 0.45mm line width is 0.44mm and I'm using Arachne.
PrusaSlicer should print the hole outer Perimeter without stopping .
Is there any way I can achieve this?
Thanks in advance
This topic was modified před 2 years by ristein
Napsal : 09/12/2022 8:59 am
RE: Need help: Thin Walls: Transition to thicker parts
is this anygood?
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Napsal : 09/12/2022 5:49 pm
Topic starter
answered:
RE: Need help: Thin Walls: Transition to thicker parts
thank you very much.
(perimeter generator to classic fixes it)
Napsal : 16/12/2022 10:06 am