Notifiche
Cancella tutti
Feed Rate "Master Volume"
Hello.
I use Prussa slicer with Ender 3.
It seems that the quality of printing improves significantly at lower speeds in my setup.
Is there a way to change feed rate as one master setting in Prussa?
I can change individual feed rates for different printing modes, yet is there a way for me to set the overall speed in % at different heights?
Is there an easy way to exclude bridge speed from this setting? Otherwise, I considered placing M220 S50 into the custom G code section to slow down all printing by default.
Is there a way to change "master" volumetric speed without changing the bridge speed?
Is this what I am talking about or is this something different? Thank you.
Postato : 15/08/2023 7:06 pm