Adventure Configuration: Fillement not extruding PrusaSlicer

Dernier message

RSS

Debbie Mango

(@debbie-mango)

New Member

Adventure Configuration: Fillement not extruding PrusaSlicer

Hi,

I am trying to use my Adventure 3, however, once it has begun to print, the filament does not seem to stick to the bed. Leaving a surplus of filament around the nozzle. Could you please point me in the right direction.

Thanks,

Paul

Publié : 18/02/2023 1:24 am

Robin

(@robin)

Noble Member

RE: Adventure Configuration: Fillement not extruding PrusaSlicer

That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset part of it...

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Publié : 18/02/2023 10:10 am

Debbie Mango

(@debbie-mango)

New Member

Topic starter answered:

RE: Adventure Configuration: Fillement not extruding PrusaSlicer

I don't think so, works fine in other included slicer. Please see link for video demonstration on what happens. https://www.dropbox.com/scl/fo/ivbkben2jvjs2llu0l8mz/h?dl=0&rlkey=e5ahs64t3aj3f85vh9pg5l8c1

Thanks

Paul

Posted by: @robin

That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset part of it...

Publié : 18/02/2023 9:05 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

24 En-ligne

68.1 K Membres

Le dernier des messages: Which version are you looking to buy? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé