Adventure Configuration: Fillement not extruding PrusaSlicer
Hi,
I am trying to use my Adventure 3, however, once it has begun to print, the filament does not seem to stick to the bed. Leaving a surplus of filament around the nozzle. Could you please point me in the right direction.
Thanks,
Paul
RE: Adventure Configuration: Fillement not extruding PrusaSlicer
That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset part of it...
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
RE: Adventure Configuration: Fillement not extruding PrusaSlicer
I don't think so, works fine in other included slicer. Please see link for video demonstration on what happens. https://www.dropbox.com/scl/fo/ivbkben2jvjs2llu0l8mz/h?dl=0&rlkey=e5ahs64t3aj3f85vh9pg5l8c1
Thanks
Paul
That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset part of it...