English
Forums
English forum
Prusa software & others
PrusaSlicer
Adventure Configuration: Fillement not extruding PrusaSlicer
 
Notifications
Clear all

Adventure Configuration: Fillement not extruding PrusaSlicer  

    Last Post
  RSS
Debbie Mango
 Debbie Mango
(@debbie-mango)
New Member
Adventure Configuration: Fillement not extruding PrusaSlicer

Hi,

I am trying to use my Adventure 3, however, once it has begun to print, the filament does not seem to stick to the bed.  Leaving a surplus of filament around the nozzle. Could you please point me in the right direction.

Thanks,

Paul

Posted : 18/02/2023 1:24 am
Robin
 Robin
(@robin)
Noble Member
RE: Adventure Configuration: Fillement not extruding PrusaSlicer

That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset  part of it...

 

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Posted : 18/02/2023 10:10 am
Debbie Mango
 Debbie Mango
(@debbie-mango)
New Member
Topic starter answered:
RE: Adventure Configuration: Fillement not extruding PrusaSlicer

I don't think so, works fine in other included slicer. Please see link for video demonstration on what happens. https://www.dropbox.com/scl/fo/ivbkben2jvjs2llu0l8mz/h?dl=0&rlkey=e5ahs64t3aj3f85vh9pg5l8c1

Thanks

Paul

Posted by: @robin

That would be the printer's manual, specifically the bed-leveling/first layer calibration/z-offset  part of it...

 

 

Posted : 18/02/2023 9:05 pm
  All forum topics
  Previous Topic
Next Topic  
Share: