Deutsch
Foren
English forum
Original Prusa CORE One
General discussion, announcements and releases
What filament dryer to use?
 
Benachrichtigungen
Alles löschen

What filament dryer to use?  

Seite 3 / 3
    Letzter Beitrag
  RSS
Crab
 Crab
(@crab)
Honorable Member
RE: What filament dryer to use?

Since I can't edit a post, here is some additional info. I had two PolyDryer units. I tested both and included some of the Serial # to identify each. So you'll see 4 plots for the PolyDryer, 2 from each unit. They were purchased a few months apart. The humidy sensor in them is accurate but it reads very high while drying due to the heated, moist air. It is accurate about 2 hours after heating is turned off and the seals are reinserted into the base of the case.

Veröffentlicht : 21/09/2025 2:51 pm
hyiger
 hyiger
(@hyiger)
Reputable Member
RE: What filament dryer to use?

Here is an interesting take on drying filament... Use the microwave: Drying Filament in a Microwave: Fast Solution or Fire Hazard? 

Not sure I want to try this however. 

Veröffentlicht : 21/09/2025 7:41 pm
Seite 3 / 3
  Alle Forumsthemen
  Vorheriges Thema
Nächstes Thema  

Kürzlich von Benutzern angesehen: Neal Vor 29 mins, Crab Vor 32 mins, Neophyl Vor 37 mins, Diem Vor 39 mins, hyiger Vor 46 mins.

Teilen: