|
I did the + upgrade as well as installed the camera. I was a... In forum User mods |
1 week ago |
|
I also suggest enabling the draft shield and maybe adjusting... In forum How do I print this? (Printing help) |
1 week ago |
|
There are a couple issues with electronics and mechanical mo... In forum General discussion, announcements and releases |
2 weeks ago |
|
I made a longer spoolholder with a cap and an extension. You... In forum General discussion, announcements and releases |
3 weeks ago |
|
I would not do it. That is a lot to add to the power supply.... In forum User mods |
2 months ago |
|
Using my similar I regularly get 15% humidity, so I did not... In forum User mods |
2 months ago |
|
Simple Dry Box For Core One + In forum User mods |
3 months ago |
|
Loosening the screws, bending then adjusting with the belt w... In forum Assembly and first prints troubleshooting |
3 months ago |
|
Is it in stealth mode? I have noticed that it is tuned to ge... In forum Assembly and first prints troubleshooting |
3 months ago |
|
Could you clarify? Are you printing from the dry box with th... In forum How do I print this? (Printing help) |
3 months ago |
|
Cutting the end at an angle has also done it for me, even wi... In forum General discussion, announcements and releases |
3 months ago |
|
I think it is pretty clear that Prusa support their stuff fo... In forum General discussion, announcements and releases |
3 months ago |
|
Prusa Connect is pretty full featured. You can stop it and y... In forum General discussion, announcements and releases |
3 months ago |
|
Unfortunately, you are about as far from them as can be. Whe... In forum General discussion, announcements and releases |
3 months ago |
|
It probably happens at the seam, where is stops one layer an... In forum How do I print this? (Printing help) |
3 months ago |
|
For some filaments, humidity affects it in hours. I always d... In forum How do I print this? (Printing help) |
3 months ago |
|
If you look at the upgrade kit: Most parts are PETG, but th... In forum General discussion, announcements and releases |
3 months ago |
|
I added a comment to the Core One -> Core One Plus upgrad... In forum Assembly and first prints troubleshooting |
4 months ago |
|
I've interacted with support chat several times and every ti... In forum General discussion, announcements and releases |
4 months ago |
|
Just a note, even though the site says a lead time of 4-5 we... In forum General discussion, announcements and releases |
4 months ago |
