|
NOPE. There is a comment a ways down that sums it up. Hot sp... In forum General discussion, announcements and releases |
3 days ago |
|
Why not go into the slicer in the Printers | Custom G-code t... In forum Hardware, firmware and software help |
5 days ago |
|
That is one reason I went with the cheap food dehydrator. If... In forum General discussion, announcements and releases |
5 days ago |
|
I just printed these with the Sunlu Easy PA. They are pretty... In forum How do I print this? (Printing help) |
6 days ago |
|
Here are my results with Sunlu Easy PA, dried at least 24 ho... In forum How do I print this? (Printing help) |
1 week ago |
|
Any dryer is better than no dryer. It always improve prints.... In forum General discussion, announcements and releases |
1 week ago |
|
It's in the Beta 2.9.3: Regards, Mark In forum General discussion, announcements and releases |
2 weeks ago |
|
One annoying thing is when the filament bound up on the spoo... In forum General discussion, announcements and releases |
3 weeks ago |
|
And, drying in a heated dryer for hours to days always, Alwa... In forum How do I print this? (Printing help) |
3 weeks ago |
|
First layer adhesion, warping and release after printing of ... In forum How do I print this? (Printing help) |
3 weeks ago |
|
I'm going to agree with this. I had the filament bind up onc... In forum General discussion, announcements and releases |
3 weeks ago |
|
I have a dryer and dry all filaments, sometimes for days bef... In forum How do I print this? (Printing help) |
3 weeks ago |
|
Try a draft shield (full height skirt) with the brim extendi... In forum Assembly and first prints troubleshooting |
4 weeks ago |
|
A few questions and observations: What are you planning to p... In forum How do I print this? (Printing help) |
1 month ago |
|
You are correct. I don't have an MMU. The vast majority of w... In forum How do I print this? (Printing help) |
1 month ago |
|
I went through all the PA presets and chose one with the clo... In forum How do I print this? (Printing help) |
1 month ago |
|
I've had reasonable luck with Sunlu Easy PA, using the setti... In forum How do I print this? (Printing help) |
1 month ago |
|
Higher temps make stringing worse. This is nothing like regu... In forum How do I print this? (Printing help) |
3 months ago |
|
I use an external dryer 100% of the time. I do see changes o... In forum User mods |
3 months ago |
|
No, but I am already at the lowest recommended temp. Regular... In forum How do I print this? (Printing help) |
3 months ago |
