need help to print SIMPLE cone shape but keep failing using MK4 and PLA

Ultimi post

RSS

3D Attic

(@3d-attic)

Trusted Member

need help to print SIMPLE cone shape but keep failing using MK4 and PLA

Hi all, i have been trying to build a small wind turbine using the ticker cad from Robert Murray Smith foind at this link https://www.tinkercad.com/things/1dTrfWXzIZt

I have fail 4 times, the shape looks easy enough but I keep getting jerking when trying to creat the side walls, I 've tried switching to vase mode and adding support and I have had to terminate after a few mins. Any thoughts please post below.

Thanks in advance

Postato : 30/08/2023 2:57 pm

Statistiche Forum

565 Forum

63.5 K Discussioni

445.6 K Post

21 Online

68.7 K Utenti

Post recenti: Buddy 3D camera can't reset Ultimo utente registrato: Frickelfred Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso