need help to print SIMPLE cone shape but keep failing using MK4 and PLA

Letzter Beitrag

RSS

3D Attic

(@3d-attic)

Trusted Member

need help to print SIMPLE cone shape but keep failing using MK4 and PLA

Hi all, i have been trying to build a small wind turbine using the ticker cad from Robert Murray Smith foind at this link https://www.tinkercad.com/things/1dTrfWXzIZt

I have fail 4 times, the shape looks easy enough but I keep getting jerking when trying to creat the side walls, I 've tried switching to vase mode and adding support and I have had to terminate after a few mins. Any thoughts please post below.

Thanks in advance

Veröffentlicht : 30/08/2023 2:57 pm

Forums-Statistiken

565 Foren

63.5 K Themen

445.6 K Beiträge

24 Online

68.7 K Mitglieder

Letzter Beitrag: Kids, don't try this at home! Unser neuestes Mitglied: Frickelfred Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen