Prusa XL from 1.6.2024
Hi guys,
I get my Prusa XL 5 Toolhead - today.
Also I make a order for the enclosure.
The enclosure will be delivered in the next few days.
I read through the instructions beforehand. And if I understand correctly, I don't have to replace any parts in PCCF - right?
If I understand correctly that all XL from June 01 have all PCCF parts already installed.
See link:
https://help.prusa3d.com/guide/4-nextruder-upgrade-multi-tool_690321
Best regards
Martin
RE:
The text specifically says Single-Tool, so I would assume that on 5 Tool would still need to upgrade the parts. Might be a typo though...
Support should be able to confirm this based on your units serial number.
RE: Prusa XL from 1.6.2024
I got my XL5T in May and it did not have the PCCF parts. I found this out when I added a 3rd party enclosure and all my extruders died due to the PETG parts warping. I reprinted in ASA and it works great.