Français
Forums
English forum
Original Prusa XL (Multi-Tool)
Assembly and first prints troubleshooting
First power up, Screen will not power on, 5v bus cycling?
 
Notifications
Clear all

First power up, Screen will not power on, 5v bus cycling?  

    Dernier message
  RSS
maxfagin
 maxfagin
(@maxfagin)
Active Member
First power up, Screen will not power on, 5v bus cycling?

On first power up, the screen didn’t turn on. I checked the electronics bay, and the every ~8 seconds, the 5V LED was coming on, staying on for <1 second, then turning off. Checked the 24V bus with a multimeter, and it is powered and stable. I’m worried I may have pinched a wire and caused a short somewhere, but before I check all of those, any other suggestions?

Publié : 03/12/2023 7:23 pm
maxfagin
 maxfagin
(@maxfagin)
Active Member
Topic starter answered:
RE:

Here is the LED cycling after startup

https://storage.googleapis.com/prusa3d-content-prod-14e8-wordpress-forum-prod/2023/12/2ec3bb3b-20231203_110257.mp4

 

Publié : 03/12/2023 9:16 pm
Hello
 Hello
(@hello)
Noble Member
RE: First power up, Screen will not power on, 5v bus cycling?

Best way to find out is unplug all but screen the plug in 1 by 1

Posted by: @maxfagin

Here is the LED cycling after startup

https://storage.googleapis.com/prusa3d-content-prod-14e8-wordpress-forum-prod/2023/12/2ec3bb3b-20231203_110257.mp4

 

 

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Publié : 04/12/2023 5:02 am
maxfagin
 maxfagin
(@maxfagin)
Active Member
Topic starter answered:
RE: First power up, Screen will not power on, 5v bus cycling?

Issue resolved. It turned out to be a faulty LCD screen. Prusa sent a replacement, and the printer is now working correctly!

Publié : 20/12/2023 2:40 am
  Tous les sujets du forum
  Sujet précédent
Sujet suivant  
Partager :