English
Forums
English forum
Original Prusa MK3.5
Hardware, firmware and software help
MK3.5 -Failed Hotend temperature test/
 
Notifications
Clear all

MK3.5 -Failed Hotend temperature test/  

Page 2 / 2
    Last Post
  RSS
GhVost
 GhVost
(@ghvost)
Member
RE: MK3.5 -Failed Hotend temperature test/

Hi everyone, sadly, I have to report the same issue with the topic starter Mk3 upgraded to 3.5. During the heater self-test, it awaits cooling to 35C and starts heating, expecting the normal heater to get to 290C in 1 minute. I even used a gas torch, but then the temperature overshoots, and at 300C, the firmware restarts the printer. Is that a bug of 6.0.4, or am I doing something wrong?

Posted : 19/08/2024 10:59 am
Benoit_79fr
 Benoit_79fr
(@benoit_79fr)
Member
RE: MK3.5 -Failed Hotend temperature test/

 

Posted by: @jimd

Thanks, lying about the nozzle type got me past the hot end check. Hopefully Prusa will fis the firmware to allow me to specify a stock hot end without the sock,

Hello,

i've use the same solution for past the hotend check with the latest firmaware 6.1.2  (08/23/2024).

 

Posted : 26/08/2024 7:05 am
Page 2 / 2
  All forum topics
  Previous Topic
Next Topic  
Topic Tags:  hotend temperatur test fa (1),
Share: