PETG and tip problems
I have finally finished the assembly of the MMU3 with my Mk3.5
MMU is printing on the defaults configs but it is not tipping like it suppose too.
I am using the Generic PETG settings and it is string when ejecting.A mix of Overture and Tinmorry.
It seems the Gray Overturn is the most problematic on the tipping.
Anybody have a customized config that would be willing to share and I can test?
Is there some good setting to cool the PETG faster with the fan to tip?
RE: PETG and tip problems
How old is the filament? In the beginning I had a lot of problems with stringy tips, the solution to this was to put all my filaments in the oven and dry them overnight. After that the tips look just like they're supposed to and I bought a standalone filament dryer.
RE: PETG and tip problems
I have them now in Creality Ecosystem and ran for 3 hours.
Will give them 6