Notifications
Clear all

Change the Extruder used for Infill?  

  RSS
Welchomatic
(@welchomatic)
Estimable Member
Change the Extruder used for Infill?

I'm about to do a print that has many filament changes, and it just struck me that because of the way the exterior of the print is laid out,  if I could change the extruder used for infill from Ext1 to Ext2 I could cut the number of filament changes down by 90%.  I can't see a way to do this in PrusaSlicer.

Does anyone have a secret way to do this?

Posted : 26/01/2020 5:57 pm
Welchomatic
(@welchomatic)
Estimable Member
Topic starter answered:
RE: Change the Extruder used for Infill?

I should mention that changing settings In Multiple Extruders  for all the infill , raft and support settings to #2, but it still want to use #1.

Posted : 26/01/2020 6:04 pm
Share: