Notifications
Clear all

MMU2 loads to extruder but no further  

  RSS
John R
(@john-r-2)
Active Member
MMU2 loads to extruder but no further

I have adjusted the MMU2 to load to the proper position to the extruder but when the extruder starts turning there is a grinding sound and it doesnt push down to the hot end.  It seems to me that the bondtech might be to far to right towards the path (or in perspective of the picture too far forward) but I dont see a way to adjust that.  see attached picture with a 1.5 allen key that doesnt even pass into the bottom tube.

Posted : 08/04/2020 11:56 pm
Share: