Help Please

Dernier message

RSS

randy.p2

(@randy-p2)

Active Member

Help Please

Hi. Hoping someone can give me some direction. I'm really having trouble with the initial calibration. No matter what I do it just will not stick all the way through the pattern. Raise it higher, nothing sticks, lower it and it clumps on the nozzle and just builds up.

Any help would be appreciated.

Thanks

Publié : 07/10/2017 5:11 pm

AJS

(@ajs)

Noble Member

Re: Help Please

Try these steps here:

http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/-before-you-ask-troubleshooting-video-updated--t472.html#p39190

If you still have problems, report what has happened at each step and we can help you out.

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Publié : 07/10/2017 6:08 pm

randy.p2

(@randy-p2)

Active Member

Topic starter answered:

Re: Help Please

Thanks for the reply!

Have some time today, so going to go through this and see what I can figure out.

Publié : 08/10/2017 4:31 pm

Statistiques du forum

559 Forums

63.1 K Sujets

443.7 K Messages

20 En-ligne

68 K Membres

Le dernier des messages: Nozzle Cleaning Failed Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé