support problem help !
Hello everyone ok there is a problem i am having with multiple pieces models and support everytime i do support this happened
i do make the support speed less but its seems it dose not work please someone tell me good setup in prusaslicer that i can use and rely on !
RE: support problem help !
Cannot see picture.
RE: support problem help !
@allen-m2
https://drive.google.com/open?id=1yjp3654jxjIeBKZa737byXxhu0Ajohha
https://drive.google.com/open?id=1x7ceIitPBVBk_Wgk_G1aEuRpmoCHz5ZM my bad i uploaded them to google drive
RE: support problem help !
Can't see all the images. The one image posted to the forum shows basic contaminated bed surface that is preventing adhesion. Soap and water will clean the surface (don't use alcohol, just use soap and water).