Notifications
Clear all

support problem help !  

  RSS
Ian baskan
(@ian-baskan)
Active Member
support problem help !

Hello everyone ok there is a problem i am having with multiple pieces models and support everytime i do support this happened *( in the pic ) not only that but somtimes support like its melting and not form good shape can somone tell my why ? 

i do make the support speed less but its seems it dose not work please someone tell me good setup in prusaslicer that i can use and rely on !

Posted : 10/12/2019 2:42 am
x50arm
(@x50arm)
Estimable Member
RE: support problem help !

Cannot see picture.

Posted : 10/12/2019 5:56 pm
Ian baskan
(@ian-baskan)
Active Member
Topic starter answered:
RE: support problem help !

@allen-m2

https://drive.google.com/open?id=1yjp3654jxjIeBKZa737byXxhu0Ajohha

https://drive.google.com/open?id=1x7ceIitPBVBk_Wgk_G1aEuRpmoCHz5ZM     my bad i uploaded them to google drive 

Posted : 10/12/2019 6:00 pm
--
 --
(@)
Illustrious Member
RE: support problem help !

Can't see all the images.  The one image posted to the forum shows basic contaminated bed surface that is preventing adhesion.  Soap and water will clean the surface (don't use alcohol, just use soap and water).

 

This post was modified 5 years ago by --
Posted : 10/12/2019 6:32 pm
Share: