Benachrichtigungen
Alles löschen
Stringing and oozing
I can't seem to find the correct settings to stop the oozing and stringing on my MK3S+. I get oozing as the hot end warms up and cools down. Stringing isn't consistent, sometimes worse than others. And I'm constantly leaving blobs of excess filament spread around my print job. These sometimes cause crashes as well.
Any and all help appreciated and acknowledged.
SteveG, AKA CodeCage
Veröffentlicht : 27/04/2024 3:46 pm
Make sure your filament is dry.
Cheerio,
Veröffentlicht : 27/04/2024 6:24 pm
Themenstarter answered:
stringing and oozing
Thanks Diem! Looks like I should go ahead and purchase that filament dryer I've had my eye on. Willing to try anything at the moment. Getting very frustrated. I used to print flawlessly.
Cheerio back at you!
Veröffentlicht : 27/04/2024 8:51 pm