Clear all

Printing issue with top piece of a small object  

Active Member
Printing issue with top piece of a small object

Hey all I am trying to print this:


Default settings work fine with size but I need to make it smaller.

This is what I shrunk it too for size   .65 x .65 x 1.5

Attached is the pic it was hard to get but the issue is with the straw at the top comes out a bit messy, any tips for that piece? The rest is perfect...

I am running this on .20 quality default settings generic PLA. Any help I would appreciate!


Posted : 14/08/2022 4:20 pm
Famed Member

Try printing multiples, three or four on the bed together will give the straw time to cool before the next layer is added.


Posted : 14/08/2022 5:07 pm