Notifications
Clear all

Printing issue with top piece of a small object  

  RSS
Mustache_Gaming
(@mustache_gaming)
Active Member
Printing issue with top piece of a small object

Hey all I am trying to print this:

https://www.thingiverse.com/thing:4851613

 

Default settings work fine with size but I need to make it smaller.

This is what I shrunk it too for size   .65 x .65 x 1.5

Attached is the pic it was hard to get but the issue is with the straw at the top comes out a bit messy, any tips for that piece? The rest is perfect...

I am running this on .20 quality default settings generic PLA. Any help I would appreciate!

 

Publié : 14/08/2022 4:20 pm
Diem
 Diem
(@diem)
Illustrious Member

Try printing multiples, three or four on the bed together will give the straw time to cool before the next layer is added.

Cheerio,

Publié : 14/08/2022 5:07 pm
Partager :