Notifiche
Cancella tutti

Overhang issues (default settings)  

  RSS
cewo
 cewo
(@cewo)
Active Member
Overhang issues (default settings)

Hello!

My prints are suddenly (?) very bad, especially the overhangs. Funny enough this happens on all my MK3S printers, using PrusaSclicer default settings, with Prusa PETG and PLA (0.1 to 0.3 mm).

The 3D-Benchy gcode prints just fine though!! 
( https://www.printables.com/model/3161-3d-benchy).

Does anyone have the same issues and hopefully a solution?

Bye, cewo

 

Postato : 26/06/2022 12:16 pm
Condividi: