New and some help with prints
Hi.
I´m Carlos from Spain, i just received my kit and printed first piece:
https://drive.google.com/open?id=1i0mDAMnefqk1fatWHOS4F_HAd3PiWKCW
https://drive.google.com/open?id=1YdTAWh4kS_wWXhc94ZiaJXTvB95RBkLP
As you can see I´m having some issues but I can´t resolve them.
Could you help me please?
Thanks.
Re: New and some help with prints
Hola Carlos,
This guide is handy for troubleshooting: https://www.simplify3d.com/support/print-quality-troubleshooting/
Suerte
Gaston
Re: New and some help with prints
My thought:
1. Over extrusion.
2. Live Z too high.
Re: New and some help with prints
I agree with Kawah
live Z too high leaving gaps between filament on the first layer
over extrusion, causing zits on the sides of the print, where the extrusion of each layer ends, and a rough top surface, where the nozzle is effectively ploughing through the hot filament.
here is another link to a different trouble shooting guide which may help you recognise the root cause of printing issues!
https://rigid.ink/pages/ultimate-troubleshooting-guide
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: New and some help with prints
Thanks to all for the help.
The problem was the pulley attached on x motor. I forgot to tighten it in next step 🙂
Regards, 