Notifications
Clear all

New and some help with prints  

  RSS
CMasso_G3D
(@cmasso_g3d)
New Member
New and some help with prints

Hi.

I´m Carlos from Spain, i just received my kit and printed first piece:

https://drive.google.com/open?id=1i0mDAMnefqk1fatWHOS4F_HAd3PiWKCW

https://drive.google.com/open?id=1YdTAWh4kS_wWXhc94ZiaJXTvB95RBkLP

As you can see I´m having some issues but I can´t resolve them.

Could you help me please?

Thanks.

Posted : 31/05/2018 12:54 pm
Gato
 Gato
(@gato)
Reputable Member
Re: New and some help with prints

Hola Carlos,

This guide is handy for troubleshooting: https://www.simplify3d.com/support/print-quality-troubleshooting/

Suerte
Gaston

Posted : 01/06/2018 3:09 am
Aravon
(@aravon)
Estimable Member
Re: New and some help with prints

My thought:
1. Over extrusion.
2. Live Z too high.

Posted : 01/06/2018 8:42 am
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: New and some help with prints

I agree with Kawah

live Z too high leaving gaps between filament on the first layer

over extrusion, causing zits on the sides of the print, where the extrusion of each layer ends, and a rough top surface, where the nozzle is effectively ploughing through the hot filament.

here is another link to a different trouble shooting guide which may help you recognise the root cause of printing issues!

https://rigid.ink/pages/ultimate-troubleshooting-guide

Regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 01/06/2018 10:05 am
CMasso_G3D
(@cmasso_g3d)
New Member
Topic starter answered:
Re: New and some help with prints

Thanks to all for the help.

The problem was the pulley attached on x motor. I forgot to tighten it in next step 🙂

Regards, :mrgreen:

Posted : 03/06/2018 6:52 pm
Share: