Notifications
Clear all
Bridges on slightly tilted flat surfaces
Hi,
Someone knows if there is a way to force Prusa Slicer to recognize low angle flat surfaces as bridges?
I mean something like this:
Here you see two down facing surfaces, one completely horizontal and the other one at 30º tilt angle, the horizontal one is recognized as a bridge while the one at 30º it is not although in my opinion it would be more convenient to print both as bridges, since both have supporting materials at both ends and the extrusion lines are horizontal in both cases.
Best,
Víctor
Publié : 15/07/2020 6:35 am