Notifications
Clear all

BLOB PROBLEM....  

  RSS
FrenkMelk
(@frenkmelk)
New Member
BLOB PROBLEM....

I have been trying to print the business end of Thor's hammer twice now and in the exact same place and around the same percentage of completeness I get a crash of the printer followed by this large blobby bit of filament right in the exact same coordinate

 

Again this is followed by a crash of the printer in a required restart from where I left off does anybody know what could be causing this very precise problem?

Posted : 06/10/2021 12:26 am
Dan Rogers
(@dan-rogers)
Noble Member
Not much to go on

Ahh, yes, the famous thors hammer issue.  Show a picture of the bottom layer please.  Add media button at the top of the text entry box.

 

Posted : 06/10/2021 7:19 am
Share: