Notifiche
Cancella tutti

What type of Gcode should I chose for Mini+ ?  

  RSS
John Dodo
(@john-dodo)
New Member
What type of Gcode should I chose for Mini+ ?

 

What type of Gcode should I chose for Mini+  in Prusa Slicer? 🤔 

Mini+ with factory firmware. 

Best Answer by FoxRun3D:

It's Marlin.

Postato : 13/07/2021 9:22 am
Cipis
(@cipis)
Utenti
RE: What type of Gcode should I chose for Mini+ ?

You can just select Prusa MINI in the wizard, it will then install all profiles and settings for you.

 

Postato : 13/07/2021 9:53 am
John Dodo hanno apprezzato
John Dodo
(@john-dodo)
New Member
Topic starter answered:
RE: What type of Gcode should I chose for Mini+ ?

@cipis

I know 🙂

Just experiment with slicer 🙂

Thnx

Postato : 13/07/2021 9:57 am
FoxRun3D
(@foxrun3d)
Famed Member
RE: What type of Gcode should I chose for Mini+ ?

It's Marlin.

Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...

Postato : 13/07/2021 11:10 am
John Dodo hanno apprezzato
Condividi: