Cancella tutti

Strange Warping  

New Member
Strange Warping

Hi there,

any Idea why my PLA prints lift themselfes up at random spots?

The Bed is clean, im printing with Das Filament PLA at 215°C/60°C (MK3s MMU2).

Any Tipps for better adhesion with this setup?



Postato : 26/05/2020 12:40 pm
Estimable Member
RE: Strange Warping

Is that the textured sheet? The plain sheet does work better but according to the Book of Joseph for the textured sheet;  "a brim may be needed for small prints and prints >180mm.....mwa ha ha ha ha..send money in a plain brown envelope and I will send a plain sheet".

OK it's not an exact quote but then I didn't exactly read the book either 🤣 🤣 



Postato : 27/05/2020 12:37 pm
RE: Strange Warping

The textured sheet must be meticulously clean for PLA to work on it... and IPA does not remove all contaminants sufficiently. 

I've also found temperature plays a major role in PLA on textured. Try bumping by 5-10C. 

Postato : 27/05/2020 2:25 pm