Strange Warping
Hi there,
any Idea why my PLA prints lift themselfes up at random spots?
The Bed is clean, im printing with Das Filament PLA at 215°C/60°C (MK3s MMU2).
Any Tipps for better adhesion with this setup?
RE: Strange Warping
Is that the textured sheet? The plain sheet does work better but according to the Book of Joseph for the textured sheet; "a brim may be needed for small prints and prints >180mm.....mwa ha ha ha ha..send money in a plain brown envelope and I will send a plain sheet".
OK it's not an exact quote but then I didn't exactly read the book either 🤣 🤣
Andrew
RE: Strange Warping
The textured sheet must be meticulously clean for PLA to work on it... and IPA does not remove all contaminants sufficiently.
I've also found temperature plays a major role in PLA on textured. Try bumping by 5-10C.