Benachrichtigungen
Alles löschen
Self test fails at hot end check: "heater/thermistor not connected" AND YET the bed and hot end heat up and PID tuning works fine
I've disconnected and reconnected all the wires from the EINSY board, checked the fuses, flashed the firmware and I'm still getting the same result.
Veröffentlicht : 07/07/2021 3:44 am
RE: Self test fails at hot end check: "heater/thermistor not connected" AND YET the bed and hot end heat up and PID tuning works fine
Welcome to the forum. You paid for support so, I suggest you contact support via Chat on the eShop.
--------------------
Chuck H
3D Printer Review Blog
Veröffentlicht : 07/07/2021 11:08 am
RE: Self test fails at hot end check: "heater/thermistor not connected" AND YET the bed and hot end heat up and PID tuning works fine
HI Joseph, did you ever get this resolved? Same issue here
Veröffentlicht : 24/11/2021 10:57 am
Themenstarter answered:
RE: Self test fails at hot end check: "heater/thermistor not connected" AND YET the bed and hot end heat up and PID tuning works fine
I don't remember. I actually checked amazon to see if I ordered a new thermistor around that time and I hadn't.
If I were to guess, it was a bad thermistor and I happened to have a spare one lying around.
Probably one of these: https://www.amazon.com/gp/product/B07QDQXDQ5/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Veröffentlicht : 23/08/2022 6:36 pm