Notifiche
Cancella tutti

Pre-Mesh Level X-axis Bug  

  RSS
Spug_Yeti
(@spug_yeti)
Active Member
Pre-Mesh Level X-axis Bug

When starting a new print (PLA. GCode generated by Slic3rPE using near-default settings) there's ~33% chance the X axis will drive itself slowly into the right Z axis lead and continue to try as the motor skips (creating a loud, rapping noise). I have no clue what causes this. Has anyone experienced this issue and/or have any resolutions?

Firmware: 3.7.0-2201

Thank you!

Postato : 18/05/2019 4:11 am
Condividi: