Notifications
Clear all

MK3S doing Z-Hop, even its turned off in PrusaSlicer  

  RSS
Panda
(@panda)
Active Member
MK3S doing Z-Hop, even its turned off in PrusaSlicer

Hi, today I discovered after some stringing problems, that the printer is doing Z-Hop, even I have turned it off (at 0mm) in PrusaSlicer.

PrusaSlicer is: 2.20

MK3S Firmware: 3.9.0

Any ideas whats the cause of this?

 

Best regards,
Dominik

Best Answer by Cipis:

Some filament profiles are using "Filament overrides" (PETG for example). Check "Filament overrides" tab in the filament settings.

Posted : 31/05/2020 4:20 pm
Cipis
(@cipis)
Member
RE: MK3S doing Z-Hop, even its turned off in PrusaSlicer

Some filament profiles are using "Filament overrides" (PETG for example). Check "Filament overrides" tab in the filament settings.

Posted : 31/05/2020 7:19 pm
Panda
(@panda)
Active Member
Topic starter answered:
RE: MK3S doing Z-Hop, even its turned off in PrusaSlicer

@roman-t

Thank you! I completely missed that setting.

Posted : 31/05/2020 7:59 pm
Share: