Notifications
Clear all
MK3S doing Z-Hop, even its turned off in PrusaSlicer
Hi, today I discovered after some stringing problems, that the printer is doing Z-Hop, even I have turned it off (at 0mm) in PrusaSlicer.
PrusaSlicer is: 2.20
MK3S Firmware: 3.9.0
Any ideas whats the cause of this?
Best regards,
Dominik
Best Answer by Cipis:
Some filament profiles are using "Filament overrides" (PETG for example). Check "Filament overrides" tab in the filament settings.
Publié : 31/05/2020 4:20 pm
RE: MK3S doing Z-Hop, even its turned off in PrusaSlicer
Some filament profiles are using "Filament overrides" (PETG for example). Check "Filament overrides" tab in the filament settings.
Publié : 31/05/2020 7:19 pm
Topic starter
answered:
RE: MK3S doing Z-Hop, even its turned off in PrusaSlicer
@roman-t
Thank you! I completely missed that setting.
Publié : 31/05/2020 7:59 pm