Notifications
Clear all

LCD Knob not working after Firmware update  

  RSS
jjessup
(@jjessup)
New Member
LCD Knob not working after Firmware update

I just flashed my MK3/MMU2s today with the latest firmware.

After a successful update to 3.11.0.4955, the encoder knob quit responding. No beep.. nothing.

I checked both cables (including continuity checks) and they were fine. Solid connections too.

I reinstalled the prior firmware that was known to work (3.10.0.4481)

At this point, the knob still isn't working, but I get a beep when I press it.

 

Any ideas?

Posted : 16/05/2022 6:20 pm
jjessup
(@jjessup)
New Member
Topic starter answered:
RE: LCD Knob not working after Firmware update

So, long story short.... I ended flashing the printer with 3.9.0, which worked. Then found out that the mmu and filament sensor cables were swapped.

After the cables were fixed, I reflashed 3.11, and everything was back to working

Posted : 17/05/2022 5:44 pm
RandyM9
(@randym9)
Honorable Member
RE: LCD Knob not working after Firmware update

Good to hear you found the issue. 

Posted : 18/05/2022 4:02 am
Share: