Notifications
Clear all
Issues leveling bed
I've had this issue before, though it has been over a year and I have forgotten how I fixed it before. The printer will usually get stuck on the 9th or 3rd point. I've looked at the pinda and I'm fairly certain it is operating fine. I had the printer running for over a week strait without issue before this started happening and I tried adjusting the height of the pinda with mixed results.
Any suggestions would be appreciated.
This topic was modified 1 year temu by Almightyeragon
Opublikowany : 17/10/2023 12:18 pm
RE: Issues leveling bed
Check for pieces of filament between the heated bed and the non stick, spring steel surface.
Opublikowany : 20/10/2023 8:54 pm