Is it possible to set the unload speed?

Dernier message

RSS

(@tt-4)

Eminent Member

Is it possible to set the unload speed?

When my MK3s unloads filament, it sometimes breaks the filament near the PTFE tube, and then loading new filament becomes a nightmare.

Is there any way to slow down the extruder speed during a firmware-initiatiated unload? This is usually a problem when changing filament during a print.

Publié : 08/12/2023 7:24 pm

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

25 En-ligne

68.9 K Membres

Le dernier des messages: Printing failure after installing 0.6 nozzle Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé