Impossible to compile and upload MK3 firmware correctly
Hello Guys,
I am a proud owner of a Prusa MK3 (I just uprgade to S version by the way) .
The MK3 works so well that I have decided to upgrade the electronic of my CR-10 S4 with an einsy Rambo and direct bondtech extruder.
So I bought all the require components and start to install it but I have an issue when I try to compile and upload the firmware on the board.
I can upload it but everytime the lcd screen show garbage characters and I can't connect octoprint to the printer
I don't understand what is wrong because I followed the instruction from the firmware Github, try different Arduino IDE, on different PC.
The problem doesn't come from the hardware, because when I flash the official ".hex" from Prusa everything is fine.
It seems to come from Arduino IDE. Is it possible to compile with another software?
I spent so many hours on the topic... so any help is welcome.
Thanks for your support !
Jérémy
RE: Impossible to compile and upload MK3 firmware correctly
Ditto, btw.
RE: Impossible to compile and upload MK3 firmware correctly
I have no issues compiling the code from git and flashing to my Mk3. Last time I've done that was yesterday. But then I'm compiling on Linux.
RE: Impossible to compile and upload MK3 firmware correctly
Did you do this?
In file "Firmware/config.h" set LANG_MODE to 0.
RE: Impossible to compile and upload MK3 firmware correctly
Did you do this?
In file"Firmware/config.h"set LANG_MODE to 0.
😱 That was the only thing I didn't try ... Now I can understand what is displayed on the screen ^^. Thanks a lot !!
I don't know why I didn't do this before.
RE: Impossible to compile and upload MK3 firmware correctly
Q:I built firmware using Arduino and printer now speaks Klingon (nonsense characters and symbols are displayed @^#$&*°;~ÿ)
A:Step 2.c was omitted.
Luckily they anticipated that and added it to the FAQ as well...
RE: Impossible to compile and upload MK3 firmware correctly
Q:I built firmware using Arduino and printer now speaks Klingon (nonsense characters and symbols are displayed @^#$&*°;~ÿ)
A:Step 2.c was omitted.
Luckily they anticipated that and added it to the FAQ as well...
My bad, I didn't scrowl down until the FAQ... I was looking for the answer on others forums 😩
By the way, I am not a Star Trek fan 😉